Skip to main content

Hot Rod & Race Car Specialist

Design - Develop - Build
About Us
Dan's 1932 Ford Roadster
Current Projects
Contact Us
Engines for Sale
Parts for Sale
Custom Motorcycle Fab
Cars & Bikes for Sale
1999 Confederate
2003 Iron Horse Chopper
1997 Viper
1999 Custom Corvette
Race Stats & Photos
Magazine Articles
Completed Projects



 $60,000.00 or Will Sell Engine and Car Separately

This car has ZERO race time and less than 1000 miles since special build.


This Corvette was designed and built by Dan Van Auken, a founding partner in Wheel to Wheel Inc. in Troy, MI. and former owner of Wheel to Wheel Racing,  a multi-championship winning Pontiac road racing team, from 1993 to 1997.


Dan has built many Corvettes for customer across the country to use road racing.  This Corvette had only 3000 street miles on it before Dan used it as a fit checking “buck” for the components he designed and built for his road racing customers.  After it was used as a “buck”, Dan personally hand built/customized this car using these special race components.  A large file of drawings, vendor specification, directions, part numbers, etc. will be provided to buyer along with wiring schematics, receipts, etc. The cost to duplicate this car would be a minimum of $150,000.00. 


Although this vehicle build incorporates too many special details to list them all, some of the special features are listed below:



     Front Charge Air Cooler Inlet Grill (This is a Dan design with costly polished casting)


     Higher Hood (Clearance for supercharger)


     Road Race Front Fascia with Carbon Splitter and Brake ducts


     Aero Rocker Trim & Euro Carbon Fiber Tail


     Special Rear Wheel Houses and Frame Modifications for 335 Tires





     Production – Cleaner than new


     Quick Release Steering Wheel

     No Air Bags




     Billet Brembo Huge Piston Front Calipers, 4-Piston Rear Calipers

     Floating Brembo Road Race Rotors




     295-17 Front - 335-18 Rear


     Wheels are Fikse Special Machined to Dan’s Specifications for fit over Rotor/Caliper



      Full 3” Stainless with 1-7/8 Stainless Headers


     Dan Van Auken built 3” Stainless Through Mufflers




     750 hp – 402 cu LS-1 Vortec Supercharged/Intercooled (Dyno Sheets Available)


     Only the best components utilized


     Oil System is Special Trap Door Road Race Type with Remote Cooler, Filter,

                      Fast Engine Management Electronics

     Transmission & Drive Shaft are ZO-6 with Road Race Blueprinting

     Clutch is Dual Disc 10 ½” McLeod




     Moton Triple Adjustable Shocks with Coil-Over Springs and Gas Canisters

     Large Front & Rear Anti-Roll Bars

     Control Arms have High Duro Bushings (GM Racing)

     Steering is Special Quick Ratio High Effort

     Hubs are Special Close Tolerance, X-Rayed

     Wheel Studs are ½-20 Fast Start




Can also construct a full road race roll cage & install safety equipment for buyer, as required.


CONTACT:  Dan Van Auken           734.776.0601.CELL     928.453.2322.SHOP